Dead hard drive advice

The forum for general posting. Come join the madness. :)
Post Reply
Message
Author
User avatar
ToLiveIsToFly
Posts: 2364
Joined: Thu Oct 11, 2007 11:34 am
Location: Kalamazoo
Contact:

Dead hard drive advice

#1 Post by ToLiveIsToFly » Sun Feb 15, 2009 7:43 pm

We've got a dead 500GB external drive that we use for backups. (Don't worry, we haven't lost any data - we are a bit paranoid about backups and have a few other volumes.)

My question is this: this dead drive had pretty much everything about our lives on it. It's dead, so I can't really wipe it, but it wouldn't surprise me if someone else with the right equipment might be able to pull data off of it.

If it were you, what would you do about disposing of it?

User avatar
Estonut
Evil Genius
Posts: 10495
Joined: Sat Oct 13, 2007 1:16 am
Location: Garden Grove, CA

Re: Dead hard drive advice

#2 Post by Estonut » Sun Feb 15, 2009 8:13 pm

Sledgehammer appetizer with a fireball entree.

Seriously, if you're worried about the data, you have to physically destroy the disk inside the drive. There is an episode of Forensic Files (on TruTV) where a police investigator was able to take a floppy disc that had been cut into pieces with those zig-zap pattern scissors, simply tape the disc back together with scotch tape, and then read enough of the floppy to convict the criminal.

Many shredders these days are made to shred credit cards and CD/DVD disks in addition to paper. I have never taken apart a hard drive to see what the actual hard disk looks like, but I wonder if you can remove it and shred it, or have it shredded.

User avatar
sunflower
Bored Hooligan
Posts: 8010
Joined: Tue Apr 08, 2008 11:32 am
Location: East Hartford, CT

Re: Dead hard drive advice

#3 Post by sunflower » Sun Feb 15, 2009 8:19 pm

I have wanted to take a sledgehammer to mine...but it's sitting in the attic until I get up the nerve!

User avatar
WebTVThingie
Merry Man
Posts: 21
Joined: Thu Jun 26, 2008 1:09 pm
Location: The landfill

Re: Dead hard drive advice

#4 Post by WebTVThingie » Sun Feb 15, 2009 8:21 pm

Try defenestration...
Cutting & pasting isn't all it's cracked up to be...

User avatar
Bob Juch
Posts: 27107
Joined: Mon Oct 08, 2007 11:58 am
Location: Oro Valley, Arizona
Contact:

Re: Dead hard drive advice

#5 Post by Bob Juch » Sun Feb 15, 2009 9:10 pm

Good for you for having your backups in order!

You should take the drive apart and subject the disk platters to the highest heat possible. That will demagnetize them. Mangle them after that if you wish.
I may not have gone where I intended to go, but I think I have ended up where I needed to be.
- Douglas Adams (1952 - 2001)

Si fractum non sit, noli id reficere.

Teach a child to be polite and courteous in the home and, when he grows up, he'll never be able to drive in New Jersey.

User avatar
sunflower
Bored Hooligan
Posts: 8010
Joined: Tue Apr 08, 2008 11:32 am
Location: East Hartford, CT

Re: Dead hard drive advice

#6 Post by sunflower » Sun Feb 15, 2009 9:16 pm

Good job catching your duplicate posts, Bob...here I was going to accuse you of trying to get your post count up! :wink:

How hot is hot enough? Hair dryer? Oven? Fireplace??

User avatar
Bob Juch
Posts: 27107
Joined: Mon Oct 08, 2007 11:58 am
Location: Oro Valley, Arizona
Contact:

Re: Dead hard drive advice

#7 Post by Bob Juch » Sun Feb 15, 2009 9:23 pm

sunflower wrote:Good job catching your duplicate posts, Bob...here I was going to accuse you of trying to get your post count up! :wink:

How hot is hot enough? Hair dryer? Oven? Fireplace??
I got an error each time I tried to post so hit reload several times.

Range burner high hot.
I may not have gone where I intended to go, but I think I have ended up where I needed to be.
- Douglas Adams (1952 - 2001)

Si fractum non sit, noli id reficere.

Teach a child to be polite and courteous in the home and, when he grows up, he'll never be able to drive in New Jersey.

User avatar
ToLiveIsToFly
Posts: 2364
Joined: Thu Oct 11, 2007 11:34 am
Location: Kalamazoo
Contact:

Re: Dead hard drive advice

#8 Post by ToLiveIsToFly » Sun Feb 15, 2009 9:39 pm

Bob Juch wrote:
sunflower wrote:Good job catching your duplicate posts, Bob...here I was going to accuse you of trying to get your post count up! :wink:

How hot is hot enough? Hair dryer? Oven? Fireplace??
I got an error each time I tried to post so hit reload several times.

Range burner high hot.
Thanks. For the record, Bob, this is the same drive you have.

User avatar
Bob Juch
Posts: 27107
Joined: Mon Oct 08, 2007 11:58 am
Location: Oro Valley, Arizona
Contact:

Re: Dead hard drive advice

#9 Post by Bob Juch » Sun Feb 15, 2009 9:57 pm

ToLiveIsToFly wrote:
Bob Juch wrote:
sunflower wrote:Good job catching your duplicate posts, Bob...here I was going to accuse you of trying to get your post count up! :wink:

How hot is hot enough? Hair dryer? Oven? Fireplace??
I got an error each time I tried to post so hit reload several times.

Range burner high hot.
Thanks. For the record, Bob, this is the same drive you have.
I hope it's several years older! Is that the Seagate or Maxtor?
I may not have gone where I intended to go, but I think I have ended up where I needed to be.
- Douglas Adams (1952 - 2001)

Si fractum non sit, noli id reficere.

Teach a child to be polite and courteous in the home and, when he grows up, he'll never be able to drive in New Jersey.

User avatar
christie1111
11:11
Posts: 11630
Joined: Tue Oct 09, 2007 8:54 am
Location: CT

Re: Dead hard drive advice

#10 Post by christie1111 » Sun Feb 15, 2009 10:15 pm

I asked this Q recently.

Breach the casing and then a high concentration of salt water was suggested.

Electrons and all that.

Think that works?
"A bed without a quilt is like the sky without stars"

User avatar
sunflower
Bored Hooligan
Posts: 8010
Joined: Tue Apr 08, 2008 11:32 am
Location: East Hartford, CT

Re: Dead hard drive advice

#11 Post by sunflower » Sun Feb 15, 2009 10:27 pm

christie1111 wrote:I asked this Q recently.

Breach the casing and then a high concentration of salt water was suggested.

Electrons and all that.

Think that works?
Ooh...a lot less dangerous than a sledgehammer or the stove top!! If that works, I'll do it tomorrow!!

User avatar
Sir_Galahad
Posts: 1516
Joined: Mon Oct 08, 2007 7:47 pm
Location: In The Heartland

Re: Dead hard drive advice

#12 Post by Sir_Galahad » Sun Feb 15, 2009 10:41 pm

As Estonut advises. I would open the drive, remove the platters and take a hammer to them making as many pieces as you can.
"All that is necessary for the triumph of evil is that good men do nothing" - Edmund Burke

Perhaps the Hokey Pokey IS what it's all about...

User avatar
ToLiveIsToFly
Posts: 2364
Joined: Thu Oct 11, 2007 11:34 am
Location: Kalamazoo
Contact:

Re: Dead hard drive advice

#13 Post by ToLiveIsToFly » Sun Feb 15, 2009 10:44 pm

Bob Juch wrote:
ToLiveIsToFly wrote:
Bob Juch wrote: I got an error each time I tried to post so hit reload several times.

Range burner high hot.
Thanks. For the record, Bob, this is the same drive you have.
I hope it's several years older! Is that the Seagate or Maxtor?
It's the Seagate. It's only 2 years old but for some reason it was prone to being knocked over. I think I told you I was having problems with mine when you first announced getting yours.

The Maxtor is in good shape. The La Cie, though - that sucker just goes and goes.

User avatar
Bob Juch
Posts: 27107
Joined: Mon Oct 08, 2007 11:58 am
Location: Oro Valley, Arizona
Contact:

Re: Dead hard drive advice

#14 Post by Bob Juch » Mon Feb 16, 2009 7:49 am

ToLiveIsToFly wrote:
Bob Juch wrote:
ToLiveIsToFly wrote: Thanks. For the record, Bob, this is the same drive you have.
I hope it's several years older! Is that the Seagate or Maxtor?
It's the Seagate. It's only 2 years old but for some reason it was prone to being knocked over. I think I told you I was having problems with mine when you first announced getting yours.

The Maxtor is in good shape. The La Cie, though - that sucker just goes and goes.
Ah, I didn't want to assume that. Mine sometimes doesn't make its presence known during a reboot. I have to get up and walk around my desk to unplug and replug it.
I may not have gone where I intended to go, but I think I have ended up where I needed to be.
- Douglas Adams (1952 - 2001)

Si fractum non sit, noli id reficere.

Teach a child to be polite and courteous in the home and, when he grows up, he'll never be able to drive in New Jersey.

Post Reply